F014001
Handling and manageability are some of the features that distinguish the pantograph designed by the Emilia Romagna company. The equipment is used for making plates via engraving. The pantograph, made of die-cast aluminium, is equipped with a high-power electric motor. The equipment is characterised by fast and simple movements: the set of arms rests on a single jointed support that oscillates by means of two ball bearings. The engraving depth can be adjusted at will thanks to the option of calibrating the cobalt tip which is located directly on the motor shaft by operating on the reader. The plate fixing system via screw stops is highly practical.
Material: aluminium SGALSI 91 uni 7369/3, hammered grey paint
Features: 1:2 engraving ratio Three-lane platform resting on rubber feet
Electrical system: 230V – 50 Hz switch Single-phase motor CE Hz 50
50W/220V 150 cm power cable with 10 A plug
Supplied: A series of letters and numbers in large block letters in brass (total 143 characters). Engraving point. Six die stops. Two plate stops. Wooden die holder box 
Watch the video
